--- title: "Homeassistant setup" date: 2024-02-12 --- ## Color fading zigbee bulbs without turning them on On HA MQTT settings page, send: ``` Topic: zigbee2mqtt/all_colortemp_lights_except_monkeylamp/set Payload: {"scene_add": {"ID": 0, "name": "house cold scene", "transition": 10, "brightness": 254, "color_temp": 0}} Topic: zigbee2mqtt/all_colortemp_lights_except_monkeylamp/set Payload: {"scene_add": {"ID": 1, "name": "house warm scene", "transition": 10, "brightness": 254, "color_temp": 320}} Topic: zigbee2mqtt/beds/set Payload: {"scene_add": {"ID": 0, "name": "beds cold scene", "transition": 10, "brightness": 254, "color_temp": 0}} Topic: zigbee2mqtt/beds/set Payload: {"scene_add": {"ID": 1, "name": "beds warm scene", "transition": 10, "brightness": 220, "color_temp": 460}} # Monkey lamp has different color temp limits, give it a separate group so it doesn't limit the other bulbs Topic: zigbee2mqtt/only_monkeylamp_for_colorchanging/set Payload: {"scene_add": {"ID": 0, "name": "monkeylamp cold scene", "transition": 10, "brightness": 254, "color_temp": 0}} Topic: zigbee2mqtt/only_monkeylamp_for_colorchanging/set Payload: {"scene_add": {"ID": 1, "name": "monkeylamp warm scene", "transition": 10, "brightness": 254, "color_temp": 320}} ``` ## Configuring no-neutral wifi switch on tasmota firmware - Sonoff SA-018 equivalent (https://www.aliexpress.us/item/3256804183990170.html) - Flash tasmota onto the module, use its hotspot to configure it onto the IoT wifi network - Find its IP address via DHCP clients list, open its web config screen, add this config: - MQTT settings, use router as mqtt host - Configure via tasmota console: - Rule1 on switch1#state do publish cmnd/foobar/SWITCH %value% endon - Rule1 1 # to enable this rule - SwitchTopic 0 # disable auto broadcast of switch state to topic - SwitchMode 1 # mode 1 = follow (0 = off, 1 = on) - PowerOnState 4 # the switch module's power output state will default to "ON" after boot, and the switch input won't affect it - socat bridge from wifi router to mqtt broker