(DIR) Return Create A Forum - Home --------------------------------------------------------- Chainsaw Repair (HTM) https://chainsawrepair.createaforum.com --------------------------------------------------------- ***************************************************** (DIR) Return to: Homelite ***************************************************** #Post#: 73121-------------------------------------------------- UT10734R won't idle By: JamesVassil Date: August 17, 2016, 3:21 pm --------------------------------------------------------- UT10734R (14") This saw was unused for several years. I filled it with a fresh mix of 32/1 (that was marked on the saw by a sharpie), cleaned and re-gapped the plug. I also put a new chain on it. It starts and runs and cuts fine but I have to keep the throttle up or it dies. I've adjusted the idle screw with no results. There are 2 other adjustment screws and I have not touched them. Someone told me they were probably the lo and hi adjustments. I don't have a shop manual so I don't know the reference points to adjust them. Thanks in advance for any help on this and hagd. Jim #Post#: 73124-------------------------------------------------- Re: UT10734R won't idle By: Chainsawrepair Date: August 17, 2016, 6:27 pm --------------------------------------------------------- UT-10734-R CS3314 IPL (HTM) https://www.partstree.com/parts/homelite/saws-chainsaw/cs3314-ut-10734-r-homelite-chainsaw/ L closest to engine, H furthest away. Try opening your L up counterclockwise. If that dont help it may be your carb diaphragms have gotten stiff. *****************************************************