(DIR) Return Create A Forum - Home --------------------------------------------------------- Chainsaw Repair (HTM) https://chainsawrepair.createaforum.com --------------------------------------------------------- ***************************************************** (DIR) Return to: Homelite ***************************************************** #Post#: 89593-------------------------------------------------- Homelite 33cc need advice By: joe_indi Date: October 28, 2022, 4:56 am --------------------------------------------------------- How do I get the oil pump worm drive off the shaft? I can move it till the threads for the clutch and no further. #Post#: 89594-------------------------------------------------- Re: Homelite 33cc need advice By: Chainsawrepair Date: October 28, 2022, 5:50 am --------------------------------------------------------- Metal spring or solid metal or nylon worm gear. Both kinds use a pullers. Sure you can come up with something. Some folks able to use flat screwdrivers and work off on different ones. IF not a press fit style. solid = (HTM) https://www.ebay.com/itm/401783145130 #Post#: 89597-------------------------------------------------- Re: Homelite 33cc need advice By: joe_indi Date: October 28, 2022, 8:26 pm --------------------------------------------------------- Metal, aluminium i think. I did try two screw drivers, since i had no puller handy tried using my oil puller and ruined it. Tried tapping it out, does not budge. Must be my second Homelite in 25 years since it is not sold here. Oil seals seem the culprit since it idles only with full choke, touch the throttle and it dies. *****************************************************