(DIR) Return Create A Forum - Home
       ---------------------------------------------------------
       Chainsaw Repair
 (HTM) https://chainsawrepair.createaforum.com
       ---------------------------------------------------------
       *****************************************************
 (DIR) Return to: Dolmar  Makita
       *****************************************************
       #Post#: 89949--------------------------------------------------
       Dolmar Makita 5100 5105 510 5000 
       By: Cut4fun Date: April 1, 2023, 8:46 am
       ---------------------------------------------------------
       Just had another class to refresh on chainsaw repair group FB on
       this chassis. So saving.
       Dolmar Makita 5100 5105 510 5000. Havent messed with these in
       years. Need refresher.
       Some PHO dry weight of the 50cc.
       510 was the open port with aluminum case.
       5100 closed port with mag case.
       5105 CAT muffler mag case.
       5000?
       #Post#: 89950--------------------------------------------------
       Re: Dolmar Makita 5100 5105 510 5000 
       By: Cut4fun Date: April 1, 2023, 8:46 am
       ---------------------------------------------------------
       Kevin LaVanway Sr
       5100S had a higher limited coil with a windowed piston. 5105
       uses a slab sided piston with a cat muffler and a lower limiter.
       Same saw otherwise.
       Kevin LaVanway Sr
       Kevin Smith
       It’s possible port timing is less jazzy in the 05. Can’t
       remember for certain. The carb is too small for huge rpm gains
       so I port them with an emphasis on torque. All of them that I
       have seen come into my shop had 3/8 on them as they should have.
       #Post#: 89951--------------------------------------------------
       Re: Dolmar Makita 5100 5105 510 5000 
       By: Cut4fun Date: April 1, 2023, 8:46 am
       ---------------------------------------------------------
       Nathaniel VansickleGroup expert
       510/5105 were available with 16, 18, 20" bars in both 325 and
       3/8. Dam near the same price no matter how they were spec. So
       most shops ordered them with 20" 3/8 and most shops that had a
       clue avoided the 3/8 18" bar because of the oddball DL count
       Nathaniel VansickleGroup expert
       510, 5121= same saw. 5100, 5105, 5000= same saw. 5001, 5105H=
       same saw as 5105 but with heated handle
       Reply
       12m
       Nathaniel VansickleGroup expert
       510/5121 were aluminum cased except the last of production run
       was mag cased... not a clue if that was the last 3 month or year
       or 2 years of production...I just know they did away with the
       aluminum case at the end.
       Reply
       10m
       Nathaniel VansickleGroup expert
       510 was built in Germany then switched to China assembly then
       back to Germany
       *****************************************************