(DIR) Return Create A Forum - Home
       ---------------------------------------------------------
       Lionel Trains
 (HTM) https://lioneltrains.createaforum.com
       ---------------------------------------------------------
       *****************************************************
 (DIR) Return to: Lionel Maintenance & Repair
       *****************************************************
       #Post#: 1088--------------------------------------------------
       Lionel #3512 rotating light pulley
       By: steina01 Date: May 25, 2015, 9:35 am
       ---------------------------------------------------------
       Hi,
       I am rehabing a 3512 fire ladder car.  Just got the rubberband
       which connects the rear axles to the pulley to activate the
       system, but can't figure out just how it should be attached.
       Can anyone help with this?
       Thanks,
       Alan
       #Post#: 1089--------------------------------------------------
       Re: Lionel #3512 rotating light pulley
       By: TrainLarry Date: May 25, 2015, 10:25 am
       ---------------------------------------------------------
       The bottom of the service manual page shows how the drive belt
       is attached around the axles and the drive pulley.
 (HTM) http://pictures.olsenstoy.com/cd/opcar%5Coc3512p2.pdf
 (HTM) http://pictures.olsenstoy.com/cd/opcar%5Coc3512p2.pdf
       Remove one end of the wheels, slide the belt over both axles,
       twist the belt 180 degrees, and stretch it over the pulley.
       Reinstall the wheels and it's done.
       Larry
       #Post#: 1090--------------------------------------------------
       Re: Lionel #3512 rotating light pulley
       By: steina01 Date: May 25, 2015, 3:19 pm
       ---------------------------------------------------------
       Thanks Larry. I had found that sheet but did not scroll down far
       enough to see the sketch of the attachment of the rubber band.
       Alan
       *****************************************************