(DIR) Return Create A Forum - Home
       ---------------------------------------------------------
       Lionel Trains
 (HTM) https://lioneltrains.createaforum.com
       ---------------------------------------------------------
       *****************************************************
 (DIR) Return to: Lionel Maintenance & Repair
       *****************************************************
       #Post#: 1912--------------------------------------------------
       Santa Fe 8352 engine slips
       By: Mr D Date: February 17, 2018, 6:34 pm
       ---------------------------------------------------------
       Hi all, new to the forum and to model trains.
       I bought a used Santa Fe 8352 Diesel Engine, which was not
       working. I took apart and cleaned the motor and armature. I was
       able to clean the copper armature, brushes, and e unit and I was
       able to get it to move and fire the lights up. However, the
       vertical engine on forward will only drive 12-14 inches and the
       motor seems to pop out of gear and revs on high without the
       train moving anymore. It seems a little better in reverse
       however does the same after a loop around the track. This is
       also without pulling any cars.
       It seems as if the worm gear is popping out of gear. The power
       truck is stamped "8250-125".
       I noticed that the plastic gear that the drive shaft is attached
       to also slips and has fallen out. I have pushed this back on.
       I tried screwing down the set drew on the plastic brush plate
       but this did not work. There is no other washers or bearings to
       adjust or replace.
       Any ideas?
       Can I rebuild this unit or just look for a new/used power truck
       to replace this one.
       I tried attaching pics but the website says the server is full.
       Thanks for any information.
       #Post#: 1913--------------------------------------------------
       Re: Santa Fe 8352 engine slips
       By: djacobsen Date: February 18, 2018, 5:20 am
       ---------------------------------------------------------
       Mr D.
       Hello & Welcome to the Forum!
       My simple solution for gears slipping on a shaft is Loc tight.
       a drop where you want the gear to stay, move it into place and
       let it cure...
       Not elegant, but works for me, hope it helps you.
       If you decide to replace,  my suggestion, if you don't have a
       LHS is to contact forum member Bill Hennings' family shop.
 (HTM) http://www.henningstrains.com/
       Happy Rails...
       dave
       #Post#: 1914--------------------------------------------------
       Re: Santa Fe 8352 engine slips
       By: Mr D Date: February 18, 2018, 7:58 pm
       ---------------------------------------------------------
       Thank you djacobsen. Will try your suggestion.
       *****************************************************