Subj : Re: Advice on the best drive emulator? To : All From : Kenzo Date : Fri May 06 2022 03:06 pm On Friday, May 6, 2022 at 12:42:48 PM UTC-7, Paul Förster wrote: > Hi, > On 06. May, 2022 at 09:54:55 CEST, "Daniel Path" wrote: > > > SD2IEC works perfectly with a c128, but i think any other device will do. :) > I second that. I love my SD2IEC. 👍 > > Cheers > Paul So my physical 1541 prevents the C128 from completing boot up when the drive is powered on and serial cable connected. If I kill the power to the drive while the 128 boot up is hung, the 128 completes booting. Same if I disconnect the serial cable while the 128 is hung on bootup. And the drive does not respond to load command, 128 reports drive not ready. I opened the drive case, board is internally very clean, and no burnt or bloated caps. I am guessing one or more of the logic chips is bad. Looks like the MOS chips are from 1984. I am using an aftermarket serial cable, the cable pins look correct when compared to online pics, and continuity pin to pin on each end is good. I guess these serial cables are supposed to be pin to pin straight wired. If I get some ambition in the next few days, I will use my scope to check for activity on the logic chips. My understanding is that with the scope ground on a chip ground and scope lead on address or data pins, I should see high speed voltage oscillation, indicating logic activity... Hate to give up on all my floppies, even if I pick up an emulator... --- SoupGate-Win32 v1.05 * Origin: Agency HUB, Dunedin - New Zealand | Fido<>Usenet Gateway (3:770/3) .