TITLE: Measuring stick for DBH measurements DATE: 2022-05-12 AUTHOR: John L. Godlee ==================================================================== When measuring the diameter of tree stems to estimate above ground woody biomass, it’s important to avoid stem features which might skew the diameter estimate and misrepresent the stem diameter. Burls, swelling at branching nodes, and large wounds should be avoided if possible. It’s convention to measure stem diameter at 1.3 m (DBH, diameter at breast height), but sometimes this will need to be changed to avoid these idiosyncratic features. Recording the height of the stem diameter measurement becomes even more important when estimating biomass change over time. If the diameter is measured at different heights in different years then any biomass change estimates will be unrealistic. Tree stems tend to taper upwards, so a diameter measurement at 1 m will generally be larger than a measurement at 1.5 m. In the field instead of using a tape measure every time you want to measure the height of the stem diameter measurement, I recommend using a measuring stick. I use a 2 m long piece of thick walled PVC pipe with duct tape markings every 10 cm, starting from 1 m and ending at 2 m. Many rolls of duct tape are exactly 5 cm wide, so conveniently I can also measure in increments of 5 cm if necessary. I mark 1.3 m using a different colour duct tape to the rest as this is the most common height for diameter measurements. Then I can hold the measuring stick up to each stem and quickly choose the appropriate height for the diameter measurement. ![Close up of the measuring scale on the DBH stick using duct tape.](https://johngodlee.xyz/img_full/dbh_stick/dbh_stick_close.jpg ) ![The DBH measuring stick, made from PVC.](https://johngodlee.xyz/img_full/dbh_stick/dbh_stick_full.jpg) The stick also comes in handy for knocking leaves out of trees for species identification, removing spider’s webs, and probing long grass for snakes. I tend to carry it with me everywhere in the plot. Additionally, I use the stick for other measurements in the plots. Counting tree saplings along 2 m wide belt transects is easy by holding the stick in the middle of the transect. Any sapling which touches the stick is counted. The stick is also useful as a way to make yourself more visible to other people in the plot when the grass is very long. When we arrive at a plot generally the first thing we do is lay out tape measures to mark the plot perimeter. To ensure these tapes are straight it’s necessary to have one person standing at the corner so the person holding the tape can walk in a straight line to them. Waving the bright green measuring stick in the air makes you much more visible. I normally attach some orange flagging tape to the top of the stick, or balance my hat on it to make it even more visible. I’ve gone back and forth on writing this brief post for a few years now. I thought that maybe it was far too obvious that a measuring stick would be useful for measuring the appropriate height for a DBH measurement. What changed my mind was having some early stage PhD students with me on fieldwork last month. They seemed to think it was a genuinely good idea, and they hadn’t already thought of it themselves, so I figured I would share it here.