Examples of ttyplot for OpenBSD


ping
Replace test.example by the host you want to ping.
ping test.example | awk '/ms$/ { print substr($7,6) ; fflush }' | ttyplot -t "ping in ms"

cpu usage
vmstat 1 | awk 'NR>2 { print 100-$(NF); fflush(); }' | ttyplot -t "Cpu usage" -s 100

disk io
 systat -d 1000 -b  iostat 1 | awk '/^sd0/ && NR > 20 { print $2/1024 ; print $3/1024 ; fflush }' | ttyplot -2 -t "Disk read/write in kB/s"

load average 1 minute
{ while :; do uptime ; sleep 1 ; done } | awk '{ print substr($8,0,length($8)-1) ; fflush }' | ttyplot -t "load average 1"

load average 5 minutes
{ while :; do uptime ; sleep 1 ; done } | awk '{ print substr($9,0,length($9)-1) ; fflush }' | ttyplot -t "load average 5"

load average 15 minutes
{ while :; do uptime ; sleep 1 ; done } | awk '{ print $10 ; fflush }' | ttyplot -t "load average 15"

wifi signal strengh
Replace iwm0 by your interface name.
{ while :; do ifconfig iwm0 | tr ' ' '\n' ; sleep 1 ; done } | awk '/%$/ { print ; fflush }' | ttyplot -t "Wifi strength in %" -s 100

cpu temperature
{ while :; do sysctl -n hw.sensors.cpu0.temp0 ; sleep 1 ; done } | awk '{ print $1 ; fflush }' | ttyplot -t "CPU temperature in °C"

pf state searches rate
systat -d 10000 -b pf 1 | awk '/state searches/ { print $4 ; fflush }' | ttyplot -t "PF state searches per second"

pf state insertions rate
systat -d 10000 -b pf 1 | awk '/state inserts/ { print $4 ; fflush }' | ttyplot -t "PF state searches per second"

network bandwidth
Replace trunk0 by your interface. This is the same command as in my previous article.

netstat -b -w 1 -I trunk0 | awk 'NR>3 { print $1/1024; print $2/1024; fflush }' | ttyplot -2 -t "IN/OUT Bandwidth in KB/s" -u "KB/s" -c "#"
Tip

You can easily use those examples over ssh for gathering data, and leave the plot locally as in the following example:

ssh remote_server "netstat -b -w 1 -I trunk0" | awk 'NR>3 { print $1/1024; print $2/1024; fflush }' | ttyplot -2 -t "IN/OUT Bandwidth in KB/s" -u "KB/s" -c "#"

or this!

ssh remote_server "ping test.example" | awk '/ms$/ { print substr($7,6) ; fflush }' | ttyplot -t "ping in ms"


sources: solene blog