2016-05-09 
       
       Chiffonier 
       
 (IMG) Image
       
       A while ago I ordered a bunch of laser cut stuff from Ponoko (see
       previous post for one), among them 1:24 scale miniature furniture.
       I finally finished assembling the most complicated one, a mirror
       chiffonier. Here's a short writeup.
       
       These types of chiffoniers were popular in beginning of 1900
       Finland, they were called peilipiironki (mirror chest of drawers).
       
       I designed it with Inkscape, using Ponoko's simple template. I
       verified all measurements, but since I knew there probably were
       mistakes that I had become blind to, I exported the plan to
       Blender, separated all the paths, gave them thickness, and
       assembled the item virtually. Surprisingly there weren't any faults
       (unlike most of the other stuff I ordered and didn't check this
       way.
        
 (HTM) Video
       
       Having a nice virtual model at my hands, I made a small animation
       illustrating the assembly.
       
 (IMG) Image
       
       Ponoko's plywood cuts come with a protective sheet on one side, and
       a sticky paper (for keeping the pieces together) on the other. I
       popped the pieces out, and took most of the charred wood from the
       edges with a small wire brush bit on a dremel.
       
 (IMG) Image
       
       I then peeled the protective stickers from the pieces, which is the
       most time consuming part of the whole build. There must be an
       intersection of people who love to peel things, and people who
       enjoy tedium, but I don't think I'm in that set.
       
 (IMG) Image
       
       Maybe I should haul all my childhood legos here... very useful for
       many purposes. I made the drawers with zero tolerance, so I wanted
       to make sure they're as narrow as possible.
       
 (IMG) Image
       
       After a bit of gluing. While the pieces have slots for alignment,
       I've left the outside surfaces (except for the back) clean, so some
       gluing needed. I used very small amounts of PVA glue.
       
 (IMG) Image
       
       After staining. I used strong instant coffee and clear spray
       lacquer. I also experimented with iron(II)acetate, but it gave a
       dull look. (You can produce it by soaking steel wool in vinegar:
       there is lots of material about this, one set of experiments here.)
       
 (IMG) Image
       
       I made the knobs from thumb tack spikes that happened to be ideal
       for the purpose. I had ordered a set of brass-tinted small nails
       for this, but they were too big.
       
       The mirror is cut from a vinyl mirror sheet. It's not ideal, a bit
       uneven, but then again antique mirrors weren't perfect either. At
       close range it works pretty well. Maybe I'll try something else
       later.
       
       (The wallpaper and the floor are just printed free textures, from
       Mydesigndeals and  AGF81.)
       
 (IMG) Image
       
       The hinges of the three doors are just pieces of copper tape. They
       do work, but probably not very long.
       
 (IMG) Image
       
       Some items for scale. I didn't have a banana. The piece is 1:24
       scale (half inch scale, meaning ½" → 1'). At 7.5 cm (3") it's the
       equivalent of 180 cm (5' 11") in real life.
       
       I had two of these cut, but only assembled one. If you want to buy
       it, assembled or DIY, contact me!