From: gopher-bounce@complete.org Date: Sun Jan 18 13:15:23 2009 Subject: [gopher] Re: gopher and IPv6 On Jan 17, 2009, at 11:34 PM, Cameron Kaiser wrote: >>>> after some tries to enable public access to my home gopher reliably >>>> (read: without NAT and other evil stuff), i'd like to set up an >>>> IPv6 >>>> gopher. But: i haven't yet managed to have any gopher daemon bind >>>> to an >>>> IPv6 port yet. What i tried so far is: GoFish and pygopherd. >>>> Anyone did this before? Or is there a gopher server that runs from >>>> xinetd? Have until now only tried standalone servers (the two named >>>> above). >>> >>> bucktooth will happily run in either environment. I haven't really >>> tested >>> it in IPv6 however (grumbles at upstream). >>> >> Well, as far as i can tell right now, bucktooth happily serves >> gopher over >> IPv6 both on IPv6-only machines as well as on dual-stack boxes. >> Configuration >> of xinetd is a tad, umm, unintuitive as i had to find out. > > Does it properly report source addresses in the log file? I am > encouraged > to hear that it operates, however. > > Once my ISP offers me IPv6, I intend to do more testing with it. I run bucktooth (0.2.6) from openbsd-inetd dual-stack. I just checked, and ipv6 source addresses are *not* correct: It always shows 0.0.0.0. Maybe I have some time next week to see if I can solve this. Regards, Jeroen Schot Thread start (DIR) [gopher] gopher and IPv6 Thread start (DIR) [gopher] gopher and IPv6 (DIR) Followup: [gopher] Re: gopher and IPv6 (DIR) Followup: [gopher] Re: gopher and IPv6 (DIR) Followup: [gopher] Re: gopher and IPv6 (DIR) Followup: [gopher] Re: gopher and IPv6